What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 24.06.2025 10:11
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
It also is a device that limits the change in current flow.
but I think this circuit , shows a few more pieces.
GM plans $4 billion push to move production from Mexico to U.S. - The Detroit News
There are three different concepts here that are getting confused.
What is lightning?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Genetic and biological clues point to inflammation’s role in mental health - PsyPost
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
One
There are two important concepts here.
Brain ‘Reset Wave’ May Explain How ECT Rapidly Relieves Depression - Neuroscience News
First Sentence:
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
A circuit breaker is similar, but is resettable.
Truck crashes into store at N.J. shopping mall, police say - NJ.com
nine
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
'No Kings' anti-Trump protests across US ahead of his military parade - BBC
what exactly is a ‘surge’ protector?
The bolt then partially travels down the line to your home.
but this device (an Inductor) … impedes the rapid changes in the current.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
A fuse is a non-resetable over current circuit protector.
a photo is worth a thousand words.
Barnstars:
An AC voltage/ current source, and an ac inductive load.
[old diagram got deleted by accident]
2024–10–14 [Omar Gharbi Omar Gharbi ]
In schematic diagrams this is the symbol for a fuse:
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Natural Tick Repellent Found—on Donkey Skin - Newser
For this case there are devices called Metal oxide varistors (MOV).
These devices are installed between the “hot” and “neutral” and protective ground.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This is 'the assistant's answer'
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Here is a simplified AC power diagram.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is the picture of an electronic coil of wire wound around a core of magnetic material.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
At one ohm, the resistor has a maximum of 1 watt power.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
(Dc diagram shown, AC is similar).
But it can get overloaded, and no longer works.
So, the voltage could go up to 500 volts, and the fuse will not open up.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
He then asserts :
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
so, what happens?
Upvotes:
[image of Common-mode choke]
This device then solves the entire problem.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
It seems Mohan does not understand the difference between a comment and an Answer.
He then describes the function of a fuse.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
the problem then depends on "how fast does the fuse operate?".
eight
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Edit 2024–10.
This one hit behind the barn.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Because the load is inductive, the current lags the voltage.(by a bit).
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
But… the neutral is now “floating” because of the 1 ohm resistance.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
I post the exact comment here.
The MOV will conduct when the voltage exceeds 50% of line voltage.
He then describes Rainy Season and Lightning.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
These are simplified answers to the original question, and does not change anything I wrote above.
Now when you have a certain ac resistance, then a current flows in a loop.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
At least they know the answer if they wanted it.
One is “what exactly is in a ‘surge protector’ ? ”
This is where the MOV conducts again, and dissipated the energy.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
What does a fuse do?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is where this question deviates from being a 'generic' question, and becomes more specific.
The third is lightning and “how it gets conducted into a home.”
2024–10–10[John johnson John Johnson ]
The other is “what does a “fuse” do?”
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.